Configuring Network Access For Static Ip Address From The Cli - HP ProLiant DL140 User Manual

2. After the connection is established, switch from the default BIOS Serial
Console connection to the CLI by first pressing and releasing the Esc key
and then simultaneously pressing the Shift + ( keys. The remote management
processor login prompt appears. The default user name is admin and the
password is admin.
3. From the CLI, enter Net, and press the Enter key to enter the Network
Configuration menu.
4. To view the DHCP IP address, enter Stat, and press the Enter key. The
following information is displayed:
face...ipsrc.....IP addr........subnet.......gateway
1-et1
16.100.248.1
5. Note the DHCP IP address for future reference.

Configuring network access for static IP address from the CLI

1. Static IP addresses can also be set using the CLI. Establish a connection to
the CLI using an external device such as a laptop or another computer that is
connected to the serial port with a null modem cable.
2. After the connection is established, switch from the default BIOS Serial
Console connection to the CLI by first pressing the Esc key and then
simultaneously pressing the Shift + ( keys. The remote management
processor login prompt appears. The default user name is admin and the
password is admin.
3. After logging in, press and release the Esc key, and press the Shift + ( keys
simultaneously to switch from BIOS serial console to the CLI.
4. From the CLI, enter Net, and press the Enter key to enter the Network
Configuration menu.
5. Enter DHCP disable, and press the Enter key. DHCP is now disabled.
6. Verify DHCP is disabled by using the stat command. If DHCP is disabled,
the default IP address 192.0.0.65 is displayed.
7. To set a static IP address, enter set ip <ip address> <net mask>
et1, and press the Enter key.
dhcp 16.100.250.72
Configuration
255.255.252.0
11