2: Ademco Contact Id Format Event Code Description - Fire-Lite Alarms Fire-Watch 411UDAC Installation, Programming, Troubleshooting And Operating Instruction Manual

Fire alarm communicator

Hide thumbs

Table Of Contents

Table of Contents

Central Station Communications

4.0.2 Ademco Contact ID Format Event Code Description

This section describes the various Event Codes and their messages which are available for the Ademco Contact ID

Format. The reporting structure for the Ademco Contact ID Format is as follows:

SSSS 18 QXYZ GG CCC

Where:

SSSS

= Four digit Subscriber ID Account Code (addresses 21 - 24 and 51 - 54)

= Identifies transmission as Contact ID to the receiver at the Central Station

= Event Qualifier where 1 = New Event and 3 = New Restore

XYZ

= Event code (shown in Tables)

= Group number

CCC

= Channel/Input number

Notes:

18, which is used in the reporting structure to identify the transmission as Contact ID, is not printed out in the

alarm and trouble report.

Q, which is the Event Qualifier for the reporting structure, is printed out in the report as an E for New Event or

R for New Restore.

GG Group Number is fixed at '00' and cannot be changed.

CCC Channel/Input Number is transmitted as '001' for Channel/Input 1, '002' for Channel/Input 2, '003' for

Channel/Input 3, '004' for Channel/Input 4.

Ademco Contact ID Reporting Structure

A typical printout from a Central Station receiver (such as the Ademco 685) of alarm and trouble reports in the

Ademco Contact ID Reporting Structure follows:

Time

Date