Microlife WatchBP office Instruction Manual page 17

Press and hold
for 7 seconds...
The default inflation pressure is 180 mmHg.
*
The device will deflate and re-pump more air into the
*
cuff if the blood pressure of the patient is higher than
that of the inflation setting of the device.
When the device is in standby mode, it will remind you
*
the current preset pressure setting by displaying the
current pressure setting on the screen.
5) Start measurements – Press the Start/Stop
Button to start the measurement sequence.
A 60-second countdown will proceed the first
*
measurement .
60-second
countdown...
6) Three consecutive measurements – The device
will take three consecutive measurements with
one minute intervals in between measurements.
60
1
seconds
60
2
seconds
16
3
EN