On Timer Operation - Sharp AF-06CSL Service Manual

AF-06CSL

ON TIMER OPERATION

• This unit has a built-in timer that can be programmed to start the unit up to 12 hours in advance. You can
set the timer to start in increments of 30 minutes (0.5 hours) up to 9.5 hours in advance of the start time,
or in 1 hour increments from 10 to 12 hours in advance of the start time.
• The unit will start automatically according to your setting.
SELECTOR indicator
COOL / FAN TEMP
SELECTOR
TIMER ON/OFF pad
TIMER indicator
(If you wish to start the operation
6 hours and 30 minutes later, set
the delay time as shown above.)
NOTES FOR TIMER SETTING AND OPERATION:
• After setting the TIMER, change the temperature and fan speed settings as shown on pages 11
and 12. When the temperature is set in the timer mode, the temperature will show in the display
for 5 seconds and then return to the time display.
• The last setting used will be memorized and will appear on the display the next time you
operate the unit with the TIMER function.
• If a power failure occurs while the ON or OFF TIMER is set, the TIMER memory will be
cancelled and will not resume even after power is reinstated. The unit will not automatically
start.
• OFF TIMER OPERATION can also be set with the REMOTE CONTROL.
1
F
POWER
ON/OFF
hr
Previous setting
TIMER ENERGY
ON/OFF SAVER
TO CANCEL THE TIMER SETTING
Touch the TIMER ON/OFF pad again after the
timer is set, or press the TIMER ON/OFF pad
until CL(cancel) appears on the display.
When the unit is not operating
Touch the TIMER ON/OFF pad to set
the delayed start time.
• The time setting will change as you touch the
pad. The display will change as follows;
Preset(0.5h)
0.5h
CL(cancel)
• The timer will be set, 5 seconds after the
TIMER ON/OFF pad is touched for the last
time.
• SELECTOR indicator and TIMER indicator
will light.
• The time display will count down the
remaining time.
• The unit will start when the set time expires.
The temperature setting will be displayed.
8
1.0h 1.5h 10h
12h 11h