Configuring The System Settings (Advanced Setup Menu) - Yamaha CX-A5100 Owner's Manual

■
System
Displays the system information on the unit.
Remote ID The unit's remote control ID setting (p.146)
TV Format The unit's video signal type (p.147)
(Asia model only)
Tuner Freq. Step
The FM/AM tuning frequency setting of the unit (p.147)
System ID System ID number
Firmware Version The version of firmware installed on the unit
• If the unit detects a newer firmware over the network, "!" (exclamation mark) appears at the upper right of
the "Information" and "System" icons, and the corresponding message will be displayed in this screen. You
can update the unit's firmware by pressing ENTER in this screen and following the procedure in "Updating
the unit's firmware via the network" (p.159).
■
Multi Zone
Displays information about Zone2, Zone3 and Zone4.
Input The input source selected for Zone2, Zone3 or Zone4
Volume The volume for Zone2 or Zone3
Configuring the system settings
(ADVANCED SETUP menu)
Configure the system settings of the unit while viewing the front display.
1
Set the unit to standby mode.
2
While holding down STRAIGHT on the front panel, press MAIN ZONE z.
MAIN ZONE z
STRAIGHT
PROGRAM
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press MAIN ZONE z to set the unit to standby mode and turn it on
again.
The new settings take effect.
145
En