Ricoh 2238c Operating Instructions Manual page 73

Q Press [Connection Test].
A connection test is performed
to check whether the specified
shared folder exists.
Note
❒ To change a path for the fold-
er that has been entered,
press [Change] located on the
left side of the destination
field. Enter a path for the
folder properly, and then
press [OK].
❒ Pressing the { { { { Check Modes} } } }
key on the control panel lets
you check the list of selected
destinations.
❒ The connection test some-
times takes time.
❒ [Connection Test] can not be
pressed right after [Cancel]
was pressed during the con-
nection test.
R To enter more destinations, re-
peat steps A A A A to Q Q Q Q .
Note
❒ To deselect a destination,
press [U U U U Prev.] or [T T T T Next] to
display the destination in the
destination field, and then
press the { { { { Clear/Stop} } } } key.
S Press [OK].
Sending Scan File by Scan to Folder
Searching to select a destination
folder from the network
A Press [Enter Destination].
B Press [SMB].
C Press [Browse Network] on the
right side of the path field.
The client computers list on the
same network appears.
Note
❒ Workgroup names or do-
m a in n am e s mu s t be s et
properly to browse the net-
work.
❒ If the client computer you
want to select is not dis-
played, press [Up One Level]
to select other workgroups,
and then you can search for
the client computer.
❒ The maximum number of cli-
ent computers and shared
folders displayed is 100.
D Select the client computer that
has the destination folder.
5
65