Setting Up Your Generator - Energizer EZG1300 User Manual

Hide thumbs Also See for EZG1300:
Table of Contents

Advertisement

Chapter 3 — Setting Up your eZG1300 Generator
Setup should be done everytime you start up your generator, these quick checks will
ensure you get the most out of your generator.
Exhaust gas contains poisonous carbon monoxide. Never run the generator
in an enclosed area. Be sure to provide adequate ventilation. Operate the
generator on a level surface. If the generator is tilted, fuel spillage may
result. Keep away from rotating parts while the generator is running. The
generator is air-cooled and may be damaged if ventilation is inadequate.
3.1 Checking the Engine Oil Level
1.
Ensure the generator is on a level surface.
2.
Inspect engine oil:
Take out the oil filler cap and clean the dipstick.
Check the oil level by reinserting the oil filler cap without rotating it. Remove
the oil filler cap and examine the oil level. If the oil level is at or below the
minimum oil level, refill the oil to the maximum oil level mark. (10W30)
Reinsert the oil filler cap and tighten securely. (Refer to figure below)
Engine oil is a major factor affecting engine performance and service life.
Non-detergent or vegetable oils are not recommended.
Maximum Oil Level
Minimum Oil Level
14
Empty
Full

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents