Configuring Key Management Function; Configuring Passwords For User Accounts; Figure 2.20 User Accounts Settings - Fujitsu ETERNUS LT260 User Manual

Chapter 2 Operating the Library
2.5 Configuring the Library
2.5.14

Configuring Key Management Function

After logging in with the security account, the Configuration > Encryption screen can be selected. For the
default library state, the hardware encryption function of the tape drive is set to be used according to the
backup software. To use the hardware encryption function of a tape drive with a single library, the Key Man-
agement Function Option is required.
When using the Key Management Function Option, refer to "FUJITSU Storage ETERNUS LT260 Tape Library Key
Management Function Option User's Guide".
2.5.15

Configuring Passwords for User Accounts

From the Configuration > User Accounts screen you can set the password for the user or administrator
accounts.
Select the user and then enter the new password twice. The password must contain 8-16 characters, which can
include upper and lower case letters, numbers, and special characters.

Figure 2.20 User accounts settings

• user
The user account allows access to library status information and does not allow access to configuration,
maintenance, or operation features. The initial password is "std00001". Setting a user password restricts
access to status information to only those who know the user password.
• administrator
Setting an administrator password provides access to the administrator functions with the remote panel or
operator panel, and restricts access to administrator functions to only those who know the administrator
password. The initial administrator password is "adm00001".
FUJITSU Storage ETERNUS LT260 Tape Library User's Guide -Panel Operation-
46
Copyright 2016 FUJITSU LIMITED P3AM-8802-04ENZ0