Focusing And Adjusting The Projector Image - SMART Board 480i6 Configuration And User's Manual

C H A P T E R 5
Maintaining your interactive whiteboard system
Before you clean the projector, press the Power
l
the system in Standby mode, and then allow the lamp to cool for at least 30 minutes.
Do not spray cleaners, solvents or compressed air directly on the projector. Do not use spray
l
cleaners or solvents near any part of the projector because they can damage or stain the unit.
Spraying the system could spread a chemical mist on some of the projector's components and
lamp, resulting in damage and poor image quality.
Do not allow liquids or commercial solvents of any kind to flow into the projector base or head.
l
I M P O R T A N T
When cleaning the interactive whiteboard system:
l
Wipe the exterior of the projector with a lint-free cloth.
o
If necessary, use a soft cloth moistened with a mild detergent to clean the projector
o
housing.
Do not use abrasive cleaners, waxes or solvents.
l
When cleaning the projector's mirror:
Use a bellows bulb or air blower bulb (commonly found in audio-visual supply stores) to blow off
l
dust. Never touch the mirror with your bare hands or a brush.
If wiping the mirror is unavoidable, wear protective gloves and gather the cleaning cloth into a
l
ball. Gently run the cleaning cloth across the mirror like you would a feather duster. Don't apply
any pressure to the lens or mirror.
When cleaning the projector's lens:
Use a bellows bulb or air blower bulb (commonly found in audio-visual supply stores) to blow off
l
dust. Never touch the lens with your bare hands or a brush.
If wiping the lens is unavoidable, wear protective gloves and gather the cleaning cloth into a ball.
l
Gently run the cleaning cloth across the lens from the center to the edge, using the cleaning cloth
like you would a feather duster. Don't apply any pressure to the lens or mirror.

Focusing and adjusting the projector image

For information on focusing and adjusting the projector image, see Focusing the image on page 18
and Adjusting the image on page 19.
30 smarttech.com/kb/170584
button twice on the remote control to put