Cleaning & Replacing Spark Plug; Maintenance - MK Diamond Products MK-2005H Owner's Manual Operating Instruction & Parts List

MK-2000 GAS SAW
CHANGING OIL
NOTE: Refer to Engine Manual for proper engine operation of your specific engine.
Oil is a major factor affecting performance and service life. Use 4-stroke automotive detergent oil.
SAE 10W-30 is recommended for general use. Other viscosity oil shown in the chart below may be
used when the average temperature in your area is within the recommended range.
NOTES:
1. Drain used oil while the engine is warm.
2. Conform to Federal, State and Local laws, codes and ordinances relative to
ENGINE AIR FILTER INSPECTION CLEANING AND REPLACEMENT
NOTE: Refer to Engine Manual for your specific engine.
FUEL SEDIMENT CUP CLEANING
Refer to Engine Manual for your specific saw.
WARNING
NOTES: 1. Conform to Federal, State and Local laws for the proper disposal of fuel.
2. Fuel can damage paint and plastic. Be careful not to spill fuel when filling the
fuel tank. Damage caused by spilled fuel IS NOt covered under the warranty.
3. DO NOt use stale or contaminated gasoline or an oil/gasoline mixture.
4. If using a stand with the MK-2000 Gas Saw, an OSHA approved ladder is
recommended when fueling.
5. When installing the Sediment Cup retaining bolt, ensure the threads of the bolt are
aligned with the threads on the Fuel Valve so as not to "cross-thread the nut."
-20ºF 0ºF
-30ºC -20ºC
environmental protection for oil disposal.
1. Gasoline is highly flammable and explosive. You can be burned or seriously
injured when handling fuel.
2. To fuel, stop engine if running and allow it to cool.
3. Refuel in a well-ventilated area
4. Keep gasoline away from appliance pilot lights, barbecues, electric
appliances, power tools, etc.
5. Wipe up spills immediately.
10W -3 0
5W -30
20ºF 40ºF 60ºF
-10ºC 0ºC 10ºC 20ºC
36

MAINTENANCE

30
80ºF
30ºC 40ºC