Advertisement
4)
Install boom frame (37) on frame (21) using bolt, lock washer, and weld nut (22), (23), (26).
5)
Slide wheels (27) on to axle followed by washer (28) and install cotter pin (59).
6)
Install boom pipe (36) to the required hole location using U bolt (38) and lock nut (57).
7)
See page 16 for pump assembly diagram. Use Teflon tape on all pipe thread fittings.
8)
Mount pump (11) and switch holder (13) to tank using screws (8).
NOTE: There is an extra 6 feet of red wire so that the switch can be mounted
ear the operator. If mounted on the tank, wrap the extra 6 feet of wire.
9)
Install grommet (16) on tank (18).
10)
Insert hose (15) through grommet (16). Lubricate grommet for ease of installation.
Note: Place hose in bottom of tank, so that it does not curl upward.
11)
Slide hose clamp (42) on hose (15) insert hose to elbow (43) on pump and tighten clamp.
From inside tank install barb (44) and strainer (45) to hose (15).
12)
Slide hose clamp (2) on hose (29), insert hose on barb hose flat (4), slide hose clamp on
opposite end of hose, and connect the hose into tee (39) and tighten clamps.
Important: Ensure direction of the Tee is as per drawing.
13)
Install clips (51) to tank (18) using screws (52).
14)
Slide hose clamp (2) on hose (55), insert hose on barb hose flat (4), slide hose clamp on
opposite end of hose, and connect the hose into barb on wand (56) and tighten clamps. Hose
can be wrapped around tank and wand inserted in clips.
15)
Install barb (17) and vinyl washer (25) to tank (18).
16)
Slide hose clamp (2) on hose (1), insert hose on barb hose flat (4) and tighten clamps.
17)
Slide hose clamp (2) on hose (1), connect hose to tee (39),and tighten clamp.
18)
Slide hose clamp (2) on hose (1), insert elbow (30) into hose and tighten clamp.
19)
Repeat 17 and 18 for the opposite side.
20)
Install steel clamp (35) on the end of boom pipe (36).
21)
Install nut (31) on elbow (30) , turn the nut up to the end of the thread on elbow nozzle.
22)
Pass elbow (30) through hole of steel clamp (35).
23)
Install o'ring (33) on filter (32). Insert filter (32) in elbow (30) and install o'ring (33), nozzle
tip (5) and nut (34) on elbow. Hand tighten nut (34).
24)
Turn nut (31) toward steel clamp (35). Do not over tighten. Adjust the nozzle spray
direction directly towards the ground.
10
Advertisement
