Advertisement
Note: Place hose in bottom of tank, so that it does not curl upward.
12)
Slide hose clamp (63) on hose (53), insert hose to elbow (31) on pump and tighten clamp.
13)
Slide hose clamp (5) on hose (13), insert hose on barb hose flat (17), slide hose clamp on
opposite end of hose, and connect hose into tee (12) and tighten clamps.
14)
Slide hose clamp (5) on hose (18), connect hose to tee (12), slide hose clamp on opposite end
of hose. Connect hose into tee (6) and tighten clamps.
15)
Slide hose clamp (5) on hose (55), connect hose to tee (6). Slide hose clamp (5) on opposite
end of hose, insert elbow (56) into hose and tighten clamp.
16)
Repeat 15 and 16 for the opposite side.
17)
Install nut (57) on elbow (56) and tee (6), turn the nut up to the end of the thread on elbow
and tee.
18)
Pass elbow (56) and tee (6) through hole on boom arms (1),(6),(19),(28).
19)
Install O-ring (58) on filter (59). Insert filter (59) in elbow (56) and tee (6) and install O-ring
(58), nozzle tip (60) and nut (61) on elbow and tee. Hand tighten nut (61).
20)
Tighten nut (57) toward boom. Do not over tighten. Adjust the nozzle spray direction
directly towards the ground.
21)
Repeats 18 – 21 for the other nozzles.
22)
Tie hoses (55),(18) using cable tie (68) on boom arm holes (1),(4),(19),(28).
23)
Install clips (38) to tank (39) using screws (37).
24)
Slide hose clamp (5) on hose (3), insert hose on barb hose flat (17), and connect the other
end of hose into barb on wand (30) and tighten clamp. Hose can be wrapped around tank and
wand inserted in clips.
25)
Slide hose clamp (5) on hose (25), insert hose on barb hose flat (17), slide hose clamp on
opposite end of hose, and connect hose to barb (33) and tighten clamps.
26)
Make sure all fittings are tight.
Note: Sprayer wand replacement tip # 8 is provided for precise spot spraying.
NOTE:
Read instruction manual and understand fully before operating the unit.
ID)
ASSEMBLY INSTRUCTION FOR 25 GAL. PULL TYPE BOOMINATOR,
ITEM # 8034888 (
1)
Install tow frame (37) on frame (35) using bolt (38) and lock nut (3).
2)
Install boom frame (1) on frame (35) using bolt (2) and lock nut (3).
YOUR SPRAYER IS READY TO USE.
. 26 & 27)
P
6
Advertisement
