Advertisement
4)
Install the red wire to a "hot" connection on the vehicle with a 12 volt DC power source or
the positive 12 volt battery post. The black wire should be grounded or connected to the
negative battery post.
5)
Add clean water into tank so that the unit can be tested. Turn the toggle switch to the "on"
position and open the valve for either the boom or wand. Adjust the desired pressure by
slowly opening or closing valve, which has the hose that returns to the tank.
6)
The wand or boom may be shut off at anytime when the pump system is
running, as the system is protected by an internal relief in the pump. It is best to
turn off the pump when it is not in use, to conserve energy from the battery.
7)
The height of the boom needs to be adjusted so that there is 50% overlap on the
spraying surface (see diagram).
SPRAYING
SURFACE
If you need to reduce the width to fewer nozzles, remove the nozzle tip and install the plug
that is provided. Not applicable to the boominator nozzle. The spray width is adjusted by
lowering or raising the boominator nozzle.
8)
If it becomes necessary to clean the filters or nozzles, remove the filter from the nozzle body.
The filter sceen may now be tapped or flushed with clear water for cleaning. Nozzles can be
cleaned by soaking in water and cleaning with a brush and airline. Never blow through by
mouth or poke with wire or pins. Not applicable to the boominator nozzle. The
boominator nozzle should never need cleaning.
9)
WARNING: Some chemicals will damage the valves if allowed to soak untreated for a
length of time. Always flush the pump with water after use. Do not allow chemicals to sit in
pump for extended times of idleness. Flushing may be done by adding water to the tank and
opening the sprayer valve (the hose that flows into the boom and wand) and run your motor
for 30-60 seconds. Follow chemical manufacturers instructions on disposal of all waste
water from the sprayer.
NOZZLES
50 %
OVERLAP
HEIGHT
12
Advertisement
