Advertisement
3)
Install tank (34) on frame (35) using bolt, lock washer, and plain washer (41), (40), (39).
4)
Install lid and outlet plug on tank (34) with tether straps.
5)
Slide tires (43) on to axle followed by washer (42) and install cotter pin (44).
6)
Insert nozzle holder (5) on boom frame (1) and lock in position using thumb screw (4).
7)
See page 16 for pump assembly diagram. Use Teflon tape on all pipe thread fittings.
8)
Mount pump (18) and switch holder (24) to tank using screws (46).
NOTE: There is an extra 6 feet of red wire so that the switch can be mounted
near the operator. If mounted on the tank, wrap the extra 6 feet of wire.
9)
Install grommet (26) on tank (34).
10)
Install barb (28) and vinyl washer (12) to tank (34).
11)
See bottom left hand view for hose assembly. Insert hose (21) through grommet (26).
Lubricate grommet for ease of installation.
Note: Place hose in bottom of tank, so that it does not curl upward.
12)
Slide hose clamp (22) on hose (21). Insert hose to elbow (29) on pump and tighten clamp.
From inside tank install barb (47) and strainer (27) to hose (21).
13)
Install clips (33) to tank (34) using screws (32).
14)
Slide hose clamp (9) on hose (49), insert hose on barb hose flat (11), and connect the other
end of hose into barb on wand (16) and tighten clamp. Hose can be wrapped around tank and
wand inserted in clips.
15)
Slide hose clamp (9) on hose (25), insert hose on barb hose flat (11), slide hose clamp on
opposite end of hose, and connect hose to barb (28) and tighten clamps
16)
Slide hose clamp (9) on hose (50), insert hose on barb hose flat (11), slide hose clamp on
opposite end of hose, and connect hose to brass barb (15) and tighten clamps.
17)
Insert brass barb (15) into hole on nozzle holder (5) and install check valve (5) (Make sure
arrows on check valve are pointing in the direction of flow.) to brass barb followed by
nozzle (7). Make sure teflon tape is used on threads. Tighten nozzle enough to prevent
leaking and make sure nozzle is pointing downwards. When sprayer is first tested with
water, rotate nozzle for even spray distribution. Do not overtighten.
18)
Make sure all fittings are tight.
Note: Sprayer wand replacement tip # 8 is provided for precise spot spraying.
NOTE: Read instruction manual and understand fully before operating the unit.
YOUR SPRAYER IS READY TO USE.
7
Advertisement
