Advertisement
11)
Install grommet (47) on tank (69).
12)
Insert hose (48) through grommet (47). Lubricate grommet for ease of installation.
13)
Slide hose clamp (46) on hose (48). Insert hose to elbow (26) on pump and tighten clamp.
From inside tank install barb (45) and strainer (44) to hose (48).
Note: Place hose in bottom of tank, so that it does not curl upward.
14)
Slide hose clamp (38) on hose (64), insert hose on barb hose flat (35), slide hose clamp on
opposite end of hose, and connect the hose into tee (52) and tighten clamps.
Important: Ensure direction of the tee is as per drawing.
15)
Install barb (25) and vinyl washer (62) to tank (69).
16)
Slide hose clamp (38) on hose (33), connect hose to barb (25), slide hose clamp on opposite
end of hose. Connect hose on barb hose flat (35) and tighten clamps.
17)
Install clips (32) to tank (69) using screws (60).
18)
Slide hose clamp (38) on hose (58), connect hose to barb hose flat (35). Connect opposite
end to wand (59). Hose can be wrapped around tank and wand inserted in clips.
19)
Install nut (6) on elbow (37) and tee (51), turn the nut up to the end of the thread on elbow
and tee.
20)
Pass elbow (37) and tee (51) through hole on boom arms (43), (50), (1), (5).
21)
Install O-ring (40) on filter (39). Insert filter (39) in elbow (37) and tee (51) and install
O-ring (40), nozzle tip (41) and nut (42) on elbow and tee.
22)
Tighten nut (6) toward boom. Do not over tighten. Adjust the nozzle spray direction
directly towards the ground.
23)
Repeat 19, 20, 21 and 22 for all nozzles.
24)
Tie hoses (49), (8) using cable tie (68) on boom arm holes (1), (5), (43), (50).
25)
Make sure all fittings are tight.
Note: Sprayer wand replacement tip # 8 is provided for precise spot spraying.
NOTE:
IB)
ASSEMBLY INSTRUCTION FOR 25 GAL. PULL TYPE DELUXE,
YOUR SPRAYER IS READY TO USE.
Read instruction manual and understand fully before operating the unit.
3
Advertisement
