Advertisement
ITEM # 8002065 (
1)
Install tow frame (33) on frame (36) using bolt (35) and lock nut (37).
2)
Install boom frame (27) on frame (36) using bolt (67) and lock nut (37).
3)
Install tank (38) on frame (36) using bolt, lock washer, and plain washer (30), (31), (32).
4)
Install lid and outlet plug on tank (38) with tether straps.
5)
Slide tires (29) on to axle and install washer (28) and cotter pin (66).
6)
Insert boom slide frame (14) on boom frame (27) and lock in position using pin (25) and
thumb screw (17).
7)
Install middle boom (18) and spacers (15) on frame boom slide (14) with bolt (13) and lock
nut (37).
8)
Install left boom (21) and right boom (4) on middle boom (18) with bolt (67) and lock nut
(37).
9)
See page 16 for pump assembly diagram. Use Teflon tape on all pipe thread fittings.
10)
Mount pump (44) and switch holder (41) to tank using screws (45).
NOTE: There is an extra 6 feet of red wire so that the switch can be mounted
near the operator. If mounted on the tank, wrap the extra 6 feet of wire.
11)
Install grommet (11) on tank (38).
12)
Install barb (39) and vinyl washer (6) to tank (38).
13)
Insert hose (57) through grommet (11). Lubricate grommet for ease of installation.
Note: Place hose in bottom of tank, so that it does not curl upward.
14)
Slide hose clamp (9) on hose (57). Insert hose to elbow (42) on pump and tighten clamp.
From inside tank install barb (58) and strainer (59) to hose (57).
15)
Install clips (63) to tank (38) using screws (64).
16)
Slide hose clamp (49) on hose (26), insert hose on barb hose flat (48), and connect the other
end of hose into barb on wand (20) and tighten clamp. Hose can be wrapped around tank and
wand inserted in clips.
17)
Slide hose clamp (49) on hose (50), insert hose on barb hose flat (48), slide hose clamp on
opposite end of hose, and connect hose to barb (39) and tighten clamps
18)
Slide hose clamp (49) on hose (10), insert hose on barb hose flat (48), slide hose clamp on
opposite end of hose, and connect hose to cross (16) and tighten clamps.
19)
Slide hose clamp (49) on hose (2), connect hose to elbow (1), slide hose clamp on opposite
end of hose. Connect hose to tee (19) and tighten clamps.
.20-22)
P
4
Advertisement
