Advertisement
4)
Install boom support (39) to brackets (6) and (38) using bolt, 2 washers, and lock nut
(5),(3),(3),(36).
5)
Insert nozzle holder (43) into boom support (39) and lock in position using thumb screw (41).
Install bolt (46) to nozzle holder with lock nut (42).
6)
See page 16 for pump assembly diagram. Use Teflon tape on all pipe thread fittings.
7)
Mount pump (29) to tank using screws (28).
8)
Install grommet (33) on tank (8).
9)
Insert hose (34) through grommet (33). Lubricate grommet for ease of installation.
Note: Place hose in bottom of tank, so that it does not curl upward.
10)
Slide hose clamp (16) on hose (34). Insert hose to elbow (30) on pump and tighten clamp.
From inside tank install barb (10) and strainer (7) to hose (34).
11)
Install barb (15) and vinyl washer (24) to tank (8).
12)
Slide hose clamp (26) on hose (13), insert hose on barb hose flat (23) and tighten clamps.
13)
Install clips (11) to tank (8) using screws (12).
14)
Slide hose clamp (26) on hose (40), insert hose on barb hose flat (23). Slide hose clamp on
opposite end of hose and connect the hose into barb on wand (14). Hose can be wrapped
around tank and wand inserted in clips.
15)
Slide hose clamp (26) on hose (27), insert hose on barb hose flat (23), slide hose clamp on
opposite end of hose, and connect hose to barb (15) and tighten clamps.
16)
Insert brass barb (47) into hole on nozzle holder (43) and install check valve (44) (Make
sure arrows on check valve are pointing in the direction of flow.) to brass barb followed
by nozzle (45). Make sure teflon tape is used on threads. Tighten nozzle enough to prevent
leaking and make sure nozzle is pointing downwards. When sprayer is first tested with
water, rotate nozzle for even spray distribution. Do not overtighten.
17)
Make sure all fittings are tight.
Note: Sprayer wand replacement tip # 8 is provided for precise spot spraying.
NOTE: Read instruction manual and understand fully before operating the unit.
A
I
IG)
SSEMBLY
1)
Install tow frame (20) on frame (21) using bolt (19) and lock nut (46).
2)
Install lid and outlet plug on tank (18) with tether straps.
3)
Install tank (18) on frame (21) using bolt, lock washer, and washer plain (22), (23), (24).
YOUR SPRAYER IS READY TO USE.
15
NSTRUCTION FOR
.
, I
GAL
PULL TYPE
TEM
# 8002001 (
. 32-34)
P
9
Advertisement
