Advertisement
25)
Repeat 20, 21, 22, 23 and 24 for the opposite side.
26)
Make sure all fittings are tight.
Note: Sprayer wand replacement tip # 8 is provided for precise spot spraying.
NOTE:
II)
ASSEMBLY INSTRUCTION FOR 15 GAL. SPOT, ITEM # 8001604 (
1)
Install lid and outlet plug on tank (14) with tether straps. Use Teflon tape on all pipe thread
fittings.
2)
Mount pump (3) to tank using screws (5) and washers (4).
3)
Install grommet (8) on tank (14).
4)
Insert hose (7) through grommet (8).
Note: Place hose in bottom of tank, so that it does not curl upward.
5)
Slide hose clamp (6) on hose (7) insert the hose to hose barb on pump
and tighten clamp. From inside tank install barb (9) and strainer (10) to hose (7).
6)
Install clips (16) to tank (14) using screws (15).
7)
Slide hose clamps (6) on hose (1) insert the hose on barb on the pump and tighten the clamp.
Slide hose clamp on opposite end of hose and connect to barb on the wand (2).
8)
Plug wire (18) to wire from pump.
9)
Make sure all fittings are tight.
Note: Sprayer wand replacement tip # 8 is provided for precise spot spraying.
NOTE: Read instruction manual and understand fully before operating the unit.
O
II
PERATION
Read operation instruction manual and run the sprayer using water only for test.
1)
This sprayer is designed to be used with a garden tractor or ATV.
2)
The pumping system draws solution from the tank to the pump. The pump
forces the solution under pressure to the boom or wand.
3)
Make sure the toggle switch is in the off position.
YOUR SPRAYER IS READY TO USE.
Read instruction manual and understand fully before operating the unit.
YOUR SPRAYER IS READY TO USE.
. 35 & 36)
P
11
Advertisement
