Advertisement
IE)
ASSEMBLY INSTRUCTION FOR 15 GAL. SPOT, ITEM # 5740063 (
1)
Install lid and outlet plug on tank (12) with tether straps.
2)
See page 16 for pump assembly diagram. Use Teflon tape on all pipe thread fittings.
3)
Mount pump (17) to tank using screws (18).
4)
Install grommet (29) on tank (12).
5)
Install barb (13) and vinyl washer (5) to tank (12).
6)
Insert hose (20) through grommet (29). Lubricate grommet for ease of installation.
Note: Place hose in bottom of tank, so that it does not curl upward.
7)
Slide hose clamp (15) on hose (20) insert the hose to elbow (14) on pump
and tighten clamp. From inside tank install barb (19) and strainer (21) to hose (20).
8)
Slide hose clamp (23) on hose (16) insert the hose on barb hose flat (4). Slide hose clamp on
opposite end of hose and connect to barb (13).
9)
Plug wire (30) to wire from pump.
10)
Install clips (24) to tank (12) using screws (25).
11)
Slide hose clamp (23) on hose (2), insert the hose on barb hose flat (4). Slide hose clamp on
opposite end of hose, and connect the hose into wand (1) and tighten clamp. Hose can be
wrapped around tank and wand inserted in clips.
12)
Make sure all fittings are tight.
Note: Sprayer wand replacement tip # 8 is provided for precise spot spraying.
NOTE: Read instruction manual and understand fully before operating the unit.
IF)
ASSEMBLY INSTRUCTION FOR 15 GAL. ATV BOOMINATOR,
ITEM # 8034879 (
1)
Install lid and outlet plug on tank (8) with tether straps.
2)
Install frames (4) to tank (8) using bolt, lock washer and plain washer (1),(2),(3).
3)
Install right bracket (6) and left bracket (38) to frame (4) using bolt, plain washer, and lock
nut (5),(3),(36). The holes that you use on the brackets are dependant on your ATV.
YOUR SPRAYER IS READY TO USE.
. 30 & 31)
P
. 28 & 29)
P
8
Advertisement
