Advertisement
20)
Slide hose clamp (49) on hose (8), connect hose to tee (19). Slide hose clamp on opposite
end of hose, connect hose to cross (16) and tighten clamps.
21)
Repeat 19 and 20 for the opposite side.
22)
Install nozzle bodies (1), (16), (19) to boom with clamps (22). The nozzle bodies should be
at 30" spacing. The inside hoses (8) are longer so that the outside booms can pivot.
23)
Insert nozzle (51) into cap (23) followed by rubber gasket (52). Insert filter (53) in nozzle
bodies (1), (16), (19). Install cap (23) on nozzle bodies (1), (16), (19) by turning half a turn.
24)
Rotate outside booms (4) and (21) so they are folded in. Install springs (7) on booms.Tighten
or loosen locknut (37) until the outside arms can rotate on their own with the spring installed.
NOTE: If locknut is too loose, movement of boom arm can be dangerous.
25)
Make sure all fittings are tight.
Note: Sprayer wand replacement tip # 8 is provided for precise spot spraying.
NOTE: Read instruction manual and understand fully before operating the unit.
IC)
A
I
SSEMBLY
NSTRUCTION FOR
I
# 8002047 (
TEM
1)
Install boom frame (48) on frame (40) using bolt (49) and lock nut (44).
2)
Install lid and outlet plug on tank (39) with tether straps.
3)
Install tank (39) on frame (40) using bolt, lock washer, and plain washer (45), (46), (47).
4)
Insert boom slide frame (11) on boom frame (48) and lock in position using pin (50) and
thumb screw (7).
5)
Install boom arm left inside (19), right inside (4) on frame boom slide (11) using carriage
bolt, plain washer, lock washer, and wing nut (14), (10), (9), (8).
6)
Install boom arm left outside (28), right outside (1) on inside boom arms
(19), (4) using bolt, plain washer, lock washer, and nut (27),(10),(9),(2).
7)
Install barb (33) and vinyl washer (21) to tank (39).
8)
See page 16 for pump assembly diagram. Use Teflon tape on all pipe thread fittings.
9)
Mount pump (34) and switch holder (32) to tank using screws (26).
NOTE: There is an extra 6 feet of red wire so that the switch can be mounted
near the operator. If mounted on the tank, wrap the extra 6 feet of wire.
10)
Install grommet (54) on tank (39).
11)
Insert hose (53) through grommet (54). Lubricate grommet for ease of installation.
YOUR SPRAYER IS READY TO USE.
25
GAL
. 23-25)
P
.
THREE POINT HITCH
,
5
Advertisement
