Table of Contents
Advertisement
Table 8 Port Status
LABEL
Name
Link
State
PD
LACP
TxPkts
RxPkts
Errors
Tx KB/s
Rx KB/s
Up Time
Clear Counter
5.5.1 Port Details
Click a number in the Port column in the Port Status screen to display individual port statistics.
Use this screen to check status and detailed performance data about an individual port on the
Switch.
Chapter 5 ZON Utility, ZON Neighbor Management and Port Status
DESCRIPTION
This is the name you assigned to this port in the Basic Setting > Port Setup screen.
This field displays the speed (such as 100M for 100 Mbps, 1000M for 1000 Mbps, or 10G
for 10 Gbps) and the duplex (F for full duplex). This field displays Down if the port is not
connected to any device.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port. (See
Section 11.1.3 on page 133
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it displays
STOP.
(For PoE models only) This field displays whether or not a powered device (PD) is allowed to
receive power from the Switch on this port.
This fields displays whether LACP (Link Aggregation Control Protocol) has been enabled on
the port.
This field shows the number of transmitted frames on this port.
This field shows the number of received frames on this port.
This field shows the number of received errors on this port.
This field shows the transmission speed of data sent on this port in kilobytes per second.
This field shows the transmission speed of data received on this port in kilobytes per second.
This field shows the total amount of time in hours, minutes and seconds the port has been
up.
Select Port, type a port number and then click Clear Counter to erase the recorded
statistical information for that port, or select Any to clear statistics for all ports.
GS3700/XGS3700 Series User's Guide
for more information).
52
Advertisement
Table of Contents
