Table of Contents
Advertisement
Table 176 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
LABEL
Port-Protocol
VLAN ID
Port VLAN ID
Dot3 TLV
Link
Aggregation
MAC/PHY
Max Frame
Size
Power Via MDI
Apply
Cancel
35.7 LLDP-MED Configuration
Click Advanced Application > LLDP > LLDP-MED Configuration to display the screen as shown
next.
Chapter 35 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
Select the check box(es) to enable or disable the sending of IEEE 802.1 Port and Protocol
VLAN ID TLVs on the port(s).
Select the check box(es) to enable or disable the sending of IEEE 802.1 Port VLAN ID
TLVs on the port(s). All check boxes in this column are enabled by default.
Select the check box(es) to enable or disable the sending of IEEE 802.3 Link Aggregation
TLVs on the port(s).
Select the check box(es) to enable or disable the sending of IEEE 802.3 MAC/PHY
Configuration/Status TLVs on the port(s). All check boxes in this column are enabled by
default.
Select the check box(es) to enable or disable the sending of IEEE 802.3 Max Frame Size
TLVs on the port(s).
Note: For PoE models only.
The Power Via MDI TLV allows network management to advertise and discover the MDI
power support capabilities of the sending port on the remote device.
•
Port Class
•
MDI Supported
•
MDI Enabled
•
Pair Controlable
•
PSE Power Pairs
•
Power Class
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
GS3700/XGS3700 Series User's Guide
364
Advertisement
Table of Contents
