"Aa Exhaust Manifold Bracket Installation; Rear Wheel Drive; "Ba Intake Manifold Stay - Installation - Mitsubishi 4G9 User Manual

11A-6-4
4G9 ENGINE (E–W) –
Bracket A
Exhaust
manifold
Exhaust
manifold
Bracket
Intake
manifold
Intake
manifold
stay
Cylinder block
"UP" mark
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
INSTALLATION SERVICE POINT

"AA EXHAUST MANIFOLD BRACKET INSTALLATION

Bracket B
<FRONT WHEEL DRIVE>
(1) Install temporarily the exhaust manifold brackets A and
(2) Check that both brackets are in close contact with the
<REAR WHEEL DRIVE>
(1) Temporarily install the exhaust manifold bracket as shown
(2) Verify that the bracket is brought into close contact with
"BA INTAKE MANIFOLD STAY INSTALLATION
<FRONT WHEEL DRIVE>
(1) Check to ensure that the intake manifold stay is in close
<REAR WHEEL DRIVE>
(1) Install the intake manifold stay with its "UP" mark directed
Nov. 1996
Mar. 2001
Intake and Exhaust Manifold
B as shown in the illustration.
bosses, and then tighten fully the bracket mounting bolts.
in the illustration.
the boss on the exhaust manifold, then tighten the bolts
to the specified torque.
contact with the intake manifold and the cylider block
before tightening the respective mounting bolts to the
specified torque.
toward the intake manifold.
PWEE9502-B
PWEE9502-I
Added
Revised