Mitsubishi 4G9 User Manual page 115

11A-8-12
4G9 ENGINE (E - W) -
Wire or MD998442
Diesel fuel
Wire or MD998442
Wire or MD998442
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
(6) Remove the lash adjuster from the container. Then, push
(7) Place the lash adjuster in container C. Then, gently push
Diesel fuel
(8) Stand the lash adjuster with its plunger at the top, then
Diesel fuel
(9) Remove the lash adjuster from the container, then stand
(10)Stand the lash adjuster upright to prevent diesel fuel from
May 1995
May 2000
Rocker Arms and Camshafts
down the steel ball gently and push the plunger to eliminate
diesel fuel from the pressure chamber.
down the internal steel ball using special tool MD998442.
Caution
Do not use container C for cleaning. If cleaning is
performed in container C, foreign matter could enter
the pressure chamber when chamber is filled with
diesel fuel.
push the plunger downward firmly until it moves through
its greatest possible stroke. Return the plunger slowly,
then release the steel ball and allow the pressure chamber
to fill with diesel fuel.
the lash adjuster with its plunger at the top. Push the
plunger firmly and check that it does not move. Also,
check that the lash adjuster's height matches that of a
new lash adjuster.
NOTE
If lash adjuster contracts, perform the operations (7)
through (9) again to fill it with diesel fuel completely.
Replace the lash adjuster if it still contracts after performing
these steps.
spilling out. Do not allow the lash adjuster to become
contaminated by dirt or other foreign matter. Fit the lash
adjuster onto the engine as soon as possible.
PWEE9502
PWEE9502-G Revised