Sealant Application To Oil Pressure Switch - Mitsubishi 4G9 User Manual

11A-9-8
Timing belt side
8 6 1
10 4 2
90_
90_
Pain mark
Oil passage
E
Mitsubishi Motors Corporation
4G9 ENGINE (E - W) -
(4) According to the tightening sequence, tighten the bolts
(5) Loosen all bolts fully.
(6) Retighten the loosened bolts to a torque of 20 Nm in
(7) Make paint marks on the cylinder head bolt heads and
3 9
(8) Give a 90_ turn to the cylinder head bolts in the specified
5 7
(9) Give another 90_ turn to the cylinder head bolts and
Caution
1. If the bolt is turned less than 90_, proper fastening
2. If the bolt is overtightened, loosen the bolt completely
"EA SEALANT APPLICATION TO OIL PRESSURE
(1) Apply sealant to the threads of the switch.
Nov. 1995
Cylinder Head and Valves
to the specified torque 74 Nm.
the specified tightening sequence.
cylinder head.
tightening sequence.
make sure that the paint mark on the head of each cylinder
head bolt and that on the cylinder head are on the same
straight line.
performance may not be expected. When tightening
the bolt, therefore, be careful to give a sufficient turn
to it.
and then retighten it by repeating the tightening
procedure from step (1).
SWITCH
Specified sealant:
3M ATD Part No. 8660 or equivalent
Caution
Use care not to allow the sealant to plug the oil
passage.
PWEE9502-A Revised