11A-6d-2
4G9 ENGINE (E - W) -
Shear-droop
Exhaust
manifold
Bracket
Intake
manifold
Intake
manifold
stay
Cylinder block
E
Mitsubishi Motors Corporation
Intake and Exhaust Manifold <4G94 - GDI for PAJERO io>
INSTALLATION SERVICE POINTS
"AA EXHAUST MANIFOLD BRACKET INSTALLATION
(1) The washers must be installed with the shear-drooped
(2) Temporarily install the exhaust manifold bracket as shown
(3) Verify that the bracket is brought into close contact with
"BA INTAKE MANIFOLD STAY INSTALLATION
(1) Check to ensure that the intake manifold stay is in close
July 2000
side toward the bolts.
in the illustration.
the boss on the exhaust manifold, then tighten the bolts
to the specified torque.
contact with the intake manifold and the cylinder block
before tightening the respective mounting bolts to the
specified torque.
PWEE9502-H
Added