Mitsubishi 4G9 User Manual page 109

11A-8-8
4G9 ENGINE (E - W) -
<DOHC - GDI for CARISMA (Up to 2000 model),
SPACE STAR (1999 model), SPACE RUNNER>
<DOHC - GDI for CARISMA (From 2001 model),
SPACE STAR (From 2001 model), GALANT, PAJERO io>
Engine front side
<DOHC - GDI for CARISMA (Up to 2000 model),
SPACE STAR (1999 model), SPACE RUNNER>
<DOHC - GDI for CARISMA (From 2001 model),
SPACE STAR (From 2001 model), GALANT, PAJERO io>
Engine front side
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
(4) Apply sealant to the illustrated position of the cylinder
(5) Install the beam camshaft cap before the sealant applied
(6) Tighten the bolts to the specified torque in the order shown
(7) Install the camshaft oil seal (use the special tool) and
MD998713
(8) Wipe off squeezed out excess sealant from the
May 1995
July 2000
Rocker Arms and Camshafts
head upper surface.
Specified sealant:
Mitsubishi Genuine Part No. MD970389
or equivalent
becomes dry and hard.
in the illustration.
M6 bolt 11Nm
M8 bolt 21Nm
Caution
The M8 bolts plated green cannot be reused. Always
replace such bolts with M8 bolts finished by glossy
plating which are available separately.
The M8 bolt finished by glossy plating is reusable;
if the caps have already been assembled with such
bolts, then reassemble the caps using them.
the thrust case <DOHC - GDI for PAJERO io - 4G93>
before the sealant applied becomes dry and hard.
circumference of the beam camshaft cap.
PWEE9502
PWEE9502-H Revised