Honda PIONEER SXS700 Owner's Manual page 130

14 SXS700-31HL36000.book 122 ページ ２０１３年５月１４日 火曜日 午前１０時５９分
Engine Oil & Filter
Add Engine Oil:
14. Remove the O-ring and sealing washer from the drain plug.
15. Install a new sealing washer onto the drain plug. Coat a new
drain plug O-ring with engine oil, and install it into the groove in
the drain plug.
16. Reinstall the drain plug, and tighten it to the specified torque:
18 lbf·ft (25 N·m , 2.5 kgf·m)
17. Reinstall the maintenance lid by tightening the bolts to the
specified torque:
9 lbf·ft (12 N·m , 1.2 kgf·m)
18. Lower your Honda SXS safely.
19. Fill the crankcase with the recommended oil, approximately:
3.1 US qt (2.9 ℓ)
20. Reinstall the oil fill cap and dipstick.
21. Start the engine and let it idle for 3 – 5 minutes.
22. Stop the engine and after 2 – 3 minutes, check the oil level. Make
sure the oil is between the upper and lower level marks on the
dipstick. If necessary, add more oil but do not overfill.
23. Reinstall the oil fill cap, dipstick and right and left rubber dust
covers.
24. Reinstall the front seat.
25. Check that there are no oil leaks.
If a torque wrench is not used for installation, see your dealer as
soon as possible to verify proper assembly.
UNDER BODY
drain plug sealing washer
drain plug O-ring
122 Servicing Your Honda