Removing The Access Panel - HP ProLiant DL145 Maintenance And Service Manual

Removing the Access Panel

1. Power down the server. Refer to the "Power ing Down the Server" section earlier in this
chapter.
2. Extend the server from the rack. Refer to the "Extending the Server from the Rack"
section earlier in this chapter.
3. Remove the access panel.
Figure 2-3: Removing the access panel
Reverse the steps to install the access panel.
HP ProLiant DL145 Server Maintenance and Service Guide
HP CONFIDENTIAL Codename: eliXir Part Number: 361543-001 Last Saved On: 3/11/04 3:21 PM
WARNING: Pressing the Power button does not remove power from all areas of the
server. Portions of the power supply and some internal circuitry remain active until the
AC power cord is removed.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal
system components to cool before touching.
CAUTION: Electrostatic discharge can damage electronic components. Properly ground
yourself before beginning any installation procedure.
Removal and Replacement Procedures
2-5