System Board - HP ProLiant DL145 Maintenance And Service Manual

System Board

To remove the system board:
1. Power down the server. Refer to "Powering Down the Server" ea rlier in this chapter.
2. Extend the server from the rack. Refer to "Extending the Server from the Rack" earlier in
this chapter.
3. Remove the access panel. Refer to "R emoving the Access Panel" earlier in this chapter.
4. Remove the PCI-X riser cage.
5. Remove the processors.
6. Remove the Processor Power Modules.
7. Remove the DIMMs.
8. Remove the video board.
9. Remove the 32-bit riser board.
10. Remove the IPMI Base Management Controller.
11. Remove the signal interface board.
12. Unscrew the system board screws.
13. Remove the system board.
Figure 2-31: Removing the system board
Reverse the steps to replace the system board.
HP ProLiant DL145 Server Maintenance and Service Guide
HP CONFIDENTIAL Codename: eliXir Part Number: 361543-001 Last Saved On: 3/11/04 3:21 PM
Removal and Replacement Procedures
2-33