D-Link DAP-1665 User Manual page 93

Section 6 - Troubleshooting
• To access the web management interface, open your web browser and enter the IP address* of your D-Link access point in
the address bar. This should open the login page for your the web management.
*Note: The default IP address is http://192.168.0.50. Once the DAP-1665 connects to your router, it will be assigned a new IP address
based on your router/network's DHCP settings. You will have to log in to your router and view the DHCP table to see what IP address
was assigned to the DAP-1665. If you are using a D-Link router, follow these instructions to find the IP address that was assigned:
Using the router's Web-based configuration utility, go to Setup > Network Settings. Scroll down to the bottom of the page, below
the heading that says Number of Dynamic DHCP Clients, to view the list of connected devices. Refer to the MAC address that is
printed on the label that is attached to the bottom of the DAP-1665 to find the corresponding IP address.
• If you still cannot access the configuration, unplug the power to the access point for 10 seconds and plug it back in. Wait about
30 seconds and try accessing the configuration. If you have multiple computers, try connecting using a different computer.
2. What can I do if I forgot my password?
If you forgot your password, you must reset your access point. Unfortunately this process will change all your settings back to
the factory default settings.
To reset the access point, locate the reset button (hole) on the rear panel of
the unit. With the access point powered on, use an unfolded paper clip to
hold the button down for 10 seconds. Release the button and the access
point will go through its reboot process.
Wait about 30 seconds to access the access point. The default IP address
is 192.168.0.50. When logging in, the username is Admin and leave the
password field empty.
D-Link DAP-1665 User Manual
Reset
92