D-Link DAP-1665 User Manual page 52

Section 3 - Configuration
If you are connecting the access point to a network which is using IPv6, the DAP-1665 can be configured to operate using the
IPv6 protocol.
When Link-Local Only is selected, this will set the access point's
My IPv6
Connection is: local IPv6 address.
The router's local IPv6 address will be displayed here. This
LAN IPv6 Link-
Local Address: address should be used to access the web-based configuration
utility through the IPv6 protocol.
Click Save Settings at the top of the page to save the current
configuration.
My IPv6 Selecting Static IPv6 from the drop-down menu will allow you
Connection is: to assign a static IPv6 address to the access point.
LAN IPv6 Enter the LAN IPv6 Address here. This address should be
Address: supplied by your Internet Service Provider (ISP).
Subnet Prefix Enter the Prefix Length for IPv6 IP addresses on your network.
Length:
Default Gateway:
Enter the default IPv6 gateway address for your network.
Primary DNS Enter the primary IPv6 DNS server address for your network.
Server:
Secondary DNS Enter the secondary IPv6 DNS server address for your network.
Server:
Click Save Settings at the top of the page to save the current
configuration.
D-Link DAP-1665 User Manual
IPv6
51