DSC Envoy NT9010 Installation Manual page 31

Se cti o n 2. 2: C ha ng i ng H o w th e NT 90 10 Wo rk s For Us er s
Door Chime Zone Attribute. . . . . . . . . . . . . . . . Sections [101] to [132], Option [3]
Verbal Chime Enabled/Disabled. . . . . . . . . . . . . . . . . . . . .Section [017], Option [2]
Verbal Chime for Zone Openings . . . . . . . . . . . . . . Section [807]-[002], Option [2]
Verbal Chime for Zone Closings . . . . . . . . . . . . . . . Section [807]-[002], Option [3]
[*] [5] Programming Access Codes
All access codes can be programmed using the [ ][5] command. For complete instructions
on programming access codes, see the NT9010 User's Guide ("Programming Access
Codes"). For information on access code attribute programming, see 2.2.2 Access Codes
on page 19.
[*] [6] User Functions
To program user functions, perform the following:
1. Press [ ] [6] [Master code]. The keypad will flash the 'System' light.
2. Press the number [1] to [7] for the item to be programmed.
• [1] - Time and Date
See the NT9010 User's Guide for instructions on setting the time and date ("Setting
the Time and Date").
• [2] - Auto-Arm Enable/Disable
Enter [2] to enable (three keypad beeps) or disable (one long beep) the auto-arm fea-
ture.
• [3] - Auto-Arm Schedule
Enter [3] to change the auto-arm time.
Enter the auto-arm time in 24-hour format (i.e. enter a 4-digit number in [hhmm]
format).
• [4] - System Test
For step-by-step instructions on performing a system test, see the NT9010 User's
Guide ("Full System Test"). When [4] is pressed the system will perform the following:
sound the alarm output for two seconds
light all lights on the keypad
sound the keypad buzzer for two seconds
test the NT9010 battery
send a System Test Reporting code, if programmed (see 2.3.12
CommunicatorReporting Codes on page 42).
• [5] - Enable DLS (Downloading)
When [5] is pressed the system will turn on the downloading option for 1 or 6 hours.
During this time the system will answer incoming downloading calls (see 2.3.14
Downloading* on page 46).
• [6] – User-Initiated Call-Up
When [6] is pressed, the system will initiate a call to the downloading computer.
• [7] Telephone Volume Control
You can change the volume of the voice prompts heard when you access the
NT9010 system by telephone. When you press [7], the NT9010 will prompt "Phone
Volume is High. To change phone volume, press '1'. To exit press #."
Options are 'Low', 'Medium', and 'High', with 'High' as the default. You can change
the current selection by pressing [1].
2 7