Adjusting The Armrests; Tyre Changing - Vermeiren Carpo 2 Instruction Manual

3.7

Adjusting the armrests

L
CAUTION: Risk of tipping over - Make sure that the armrests are positioned symmetrically
from the seat.
L
CAUTION: Risk of injury - Mount the inner tube always with of safe distance of 50 mm in
the outer tube.
The armrest can be adjusted in height and depth.
3.8

Tyre changing

L
CAUTION: There must be no air in the tube before it can be removed.
L
CAUTION: Risk of damage - If handled improperly, the rim might be damaged.
Note the following before inserting the new tube:
Check the rim bed and the inside wall of the tyre for foreign matter and clean these properly if
necessary. Check the condition of the rim bed, especially around the position of the air valve. Please
use only genuine original replacement parts. No liability is accepted for damage caused by non-
genuine replacement parts. Kindly contact your specialist dealer.
Assembly:
L
WARNING: Risk of injury - Check that the pressure is correct.
L
CAUTION: Risk of injury - Make sure that no objects or body parts are pinched between the
tyre and the rim when mounting a tyre.
L
WARNING: Risk of injury - Make sure all screws are firmly secured by hand before driving
with your scooter. Screw adhesive (ex. Loctite) should be applied to the screws on the
flange. Screw adhesive will only work if the thread is free of grease and particles.
3.7.1 Adjusting height armrests
L
CAUTION: Risk of injury - Do not put your fingers,
buckles, clothes, jewelry between the swing away
system of the armpad.
1. Fold the armpad  backwards.
2. Loosen the star knob .
3. Grasp the armpad  as shown in the picture.
4. Move the armpad  upwards or downwards until the
desired height (range: 120 mm stepless).
5. Retighten the star knob .
6. Check that the armrest is fixated very well.
3.7.2 Adjusting depth armrests
1. Loosen the star knob  on the back of the scooter.
2. Grasp the inner square tube as shown in the picture.
3. Move these tube to adjust the armrest  to the desired
depth (range: 100 mm each side stepless).
4. Retighten the star knob .
5. Check that the armrest is fixated very well.
Page 24
Carpo 2
2015-07