Table of Contents
Advertisement
The device supports up to four multiple Service Set Identifiers. You can back to the Basic Settings page to
set the Primary SSID. The SSID's factory default setting is Planet 5G VAP1~4 (Multiple-SSID 1~4). The
SSID can be easily changed to connect to an existing wireless network or to establish a new wireless
network. When the information for the new SSID is finished, click the Apply Changes button to let your
changes take effect.
Once you have applied and saved those settings, you can then go to the "WLAN1 (5GHz) → Security"
page on the AP to set up security settings for each of the SSIDs.
Universal Repeater
This mode allows the AP with its own BSS to relay data to a root AP to which it is associated with WDS
disabled. The wireless repeater relays signal between its stations and the root AP for greater wireless
range.
Internet
Example of how to configure Universal Repeater Mode. Please take the following steps:
1.
To configure each wireless parameter, please go to the "WLAN1 (5GHz) → Basic Settings" page.
Step 1. Configure wireless mode to "AP" and then check "Enable Universal Repeater Mode (Acting as AP
Figure 5-20 5GHz Multiple-SSID
Universal Repeater Mode
WDAP-C7200AC
a/n/ac
5G
a/n/ac
2.4G
AP
g/n
Smart Phone
-33-
User Manual of WDAP-C7200AC
Switch
g/n
Clients
Advertisement
Table of Contents
