Table of Contents
Advertisement
Subnet Mask
Default Gateway
DHCP
DHCP Client Range
Static DHCP
Domain Name
802.1d Spanning Tree
Clone MAC Address
UPnP Enable
If you change the IP address of LAN, you must use the new IP address to login the
AP.
When the IP address of the WDAP-C7200AC is changed, the clients on the
network often need to wait for a while or even reboot before they can access the
new IP address. For an immediate access to the AP, please flush the netbios
cache on the client computer by running the "nbtstat –r" command before using
the device name of the WDAP-C7200AC to access its Web Management page.
Default is 255.255.255.0. You can change it according to your request.
Default is 192.168.1.253. You can change it according to your request.
You can select a Disabled, Client, and Server. Default is Disabled,
meaning the WDAP-C7200AC must connect to a router to assign IP
addresses to clients.
For the Server mode, you must enter the DHCP client IP address
range in the field. And you can click the "Show Client" button to show
the Active DHCP Client Table.
Click the "Set Static DHCP" button and you can reserve some IP
addresses for those network devices with the specified MAC
addresses anytime when they request IP addresses.
Default is Planet.
You can enable or disable the Spanning Tree function.
You can input an MAC address here for using clone function.
You can enable or disable the UPnP function.
The UPnP feature allows the devices, such as Internet computers, to
access the local host resources or devices as needed. UPnP devices
can be automatically discovered by the UPnP service application on
the LAN.
-28-
User Manual of WDAP-C7200AC
Advertisement
Table of Contents
