Switching On The Camera - KeepGuard KG760EB Instruction Manual

· If the motion indicator LED light blinks, it indicates that position can be
sensed. If it does not blink, that position is outside of the sensing area. The
results of your testing will help you find the best placement when mounting and
aiming the KeepGuard Cam. The height away from the ground for placing the
device should vary with the animal size appropriately. In general, 3 to 6 feet is
preferred. You can avoid potential false triggers due to temperature and
motion disturbances in front of the camera by not aiming it at a heat source or
nearby tree branches or brush (especially on windy days).

Switching ON the Camera

Once you switch to the ON mode, the motion indicator LED (red) will blink for
about 10 seconds. This gives you time to close and lock the front cover of the
KeepGuard Cam and then walk away. During this time, the motion indicator
LED will blink red continuously. After it stops blinking, the PIR is active, and
any motion that is detected by it will trigger the capture of photos or videos as
programmed in the SETUP Menu. Be sure you have read the descriptions of
the Capture Number, Video Length, Interval and Sensor Level parameters.
Please note, the PIR is strongly sensitive to ambient temperature. The greater
the temperature difference between the environment and your subject, the
farther the possible sensing distance. The average sensing distance is about
45 ft.
22