Setup Mode - KeepGuard KG760EB Instruction Manual

the ON mode, no manual controls are needed or possible (the control keys
have no effect). The KeepGuard Cam will take photos or videos automatically
(according to its current parameter settings) when it is triggered by the PIR
sensor's detection of activity in the area it covers. You can either move the
power switch directly from OFF to ON mode, or stop at the SETUP position
first to change one or more settings, then move the switch to ON after you
have finished doing so.

SETUP Mode

In the SETUP mode you can check and change the settings of the KeepGuard
Cam with the help of its built-in LCD (or a monitor connected to the TV out
jack). These settings, found in the SETUP Menu, let you change the photo or
video resolution, interval between photos, switch the time imprint on, etc.
Moving the power switch to the SETUP position will turn on the LCD display,
and you will see an information screen that shows how many images have
been taken, the battery level, camera or video mode, etc. (see Fig. 3 below).
NOTE: always move the power switch from OFF to SETUP mode. It is
possible that the camera could lockup if it is switched from ON to SETUP
mode. If this occurs, simply move the switch to OFF and then push it up to
SETUP again.
11