Returning To The Factory Settings - Yamaha YVC-1000 User Manual

Returning to the factory settings

Return the settings of the product to the factory settings.
1
When the power is on (the power
button ( ) lights up green), press
and hold the power button (
seconds or more to enter standby
mode.
The product enters the standby mode, and the power
button ( ) lights up red.
2
Press the power button (
holding down the tuning fork button
( ) and the volume - button (
the same time, then release the
power button (
The lamps on the level indicator will light up
moving horizontally, and the power-on operation
starts. Be sure to hold down the tuning fork button
( ) and the volume - button (
33
) for 2
) while
) at
) only.
).
3
When various settings are reset to
their factory defaults, you will be
notified by English voice guidance.
When the level indicator is turned off,
release the tuning fork button (
and the volume - button (
y
• Even if the voice guidance is disabled before returning to
factory settings, the voice guidance will notify the user in
English when the settings of the product are returned to
factory settings.
• When the settings are returned to the factory settings,
Bluetooth pairing information is also erased. Refer to
"Setup" (page 11) and the subsequent sections to set the
product up again.
)
).