Dante Settings; Connecting To Dante Devices - Yamaha DZR315-D Reference Manual

System setup example
This example uses only DZR-D and DXS-XLF-D series speakers.
Side (L)
I/O rack
L2 switch
MONI1
Ethernet cable
for Dante
Digital mixer
Configuration with Dante Models
Limit the number of Dante devices to within 10 units, including switches, in a single
daisy chain. If the number of Dante devices exceeds 10 units, communication
latency within the network will increase and the audio might drop out. To prevent
this, set a higher Dante Latency value
(that supports Giga-bit Ethernet) to create branches in the network.
NOTE
It is important to setup a well-balanced system that leverages the advantages offered by both daisy
chain and star network connections.
FOH (L) FOH (R) Side (R)
(L) (R)
MONI2 MONI3 MONI4
24, t LATENCY), or use an L2 switch
(page

Dante Settings

When using the DZR-D and DXS-XLF-D in a connection to a Dante network, use the
DANTE SETUP screen to configure various Dante settings.
Navigate from the HOME screen and select UTILITY → DANTE SETUP to open the
DANTE SETUP screen. To open the DANTE SETUP screen, you can also navigate from
the HOME screen and select UNIT ID, LABEL (the upper left of the HOME screen). See
page 13.
DANTE SETUP screen
* For more information about each function, see "Screen Functions" – "UTILITY Screen" –
" DANTE SETUP" (page 23).

Connecting to Dante Devices

 About Dante Controller
Dante Controller is a software application that allows configuration and audio routing of
Dante networks. Use this application if you plan to connect to Dante devices other than
Yamaha digital mixers compatible to integration with DZR-D and DXS-XLF-D, or apply
more advanced settings.
Please download the latest version of the Dante Controller application from the website
listed below.
http://www.yamahaproaudio.com/
To run Dante Controller, the computer must feature a GbE (Giga-bit Ethernet)-compatible
connector.
In Dante Controller, you can apply the following main settings.
• I/O patch settings on the Routing tab in Network View
• Clock master settings on the Clock Status tab in Network View
• Sampling rate settings on the Device Config tab in Device View
Screen Functions
30