Temperature; Winterizing; Service Instructions; Change Of Switch (Pos A) Wd 5.2 - Johnson Pump WD 2.9 Instruction Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 8
Caution
Do not use pump for any other liquids
than fresh-water and sea-water.

Temperature

Max liquid temperature: +50°C/+120°F
Max ambient temperature: +60°C/+140°F

Winterizing

If water is not drained from the system
during freezing temperatures, damage is
likely to be sustained in the plumbing and
in the pump. To prevent damage follow
the instructions beneath:
1. Disconnect suction hose from water
supply (sea water supply) or if water
supply is taken from a tank, drain water
storage tank.
2. Open all spray nozzles/taps.
3. Run pump until remaining water is
expelled.
4. Disconnect inlet and outlet tubes.
5. Run pump briefly to confirm that water
has been expelled.
6. Spray nozzles/taps shall remain open
and pump fittings shall remain discon-
nected until temperatures are above
freezing
Never start a frozen pump. Even if it is
drained it might contain a small amount of
frozen water that locks the rotor.

Service instructions

(see page 42-47)
Change of Switch (pos A) WD
2.9/3.5
1. Remove the cables from the power
source.
2. Remove the screws (27) and then
remove the complete switch including
diaphragm (18).
3. Cut the connection to the motor (red).
Original instructions
4. Locate the new diaphragm (18) and
then the new complete switch.
5. Take the new switch and attach the
cables to motor and power source.
Use the attached jointing sleeve to
connect the motor cable.

Change of Switch (pos A) WD 5.2

1. Remove the cables from the power
source.
2. Remove the screws (28) and then re-
move the complete switch including
diaphragm (19).
3. Cut the connection to the motor
(red).
4. Locate the new diaphragm (19) and
then the new complete switch.
5. Take the new switch and attach the
cables to motor and power source.
Use the attached jointing sleeve to
connect the motor cable.
Accessories
(See page 41)
Waste handling & material recy-
cling
At the products end of life, please dis-
pose of the product according to app-
licable law. Where applicable, please
disassemble the product and recycle
the parts material.
> English
11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wd 5.2Wd 3.5

Table of Contents