Introduction; Installation Of Ethernet Driver; Installation For Ms-Dos & Windows 3.1 - Advantech PCM-5820 Manual

7.1

Introduction

The PCM-5820 is equipped with a high performance 32-bit
Ethernet chipset which is fully compliant with IEEE 802.3 100
Mbps CSMA/CD standards. It is supported by major network
operating systems. It is also both 100Base-T and 10Base-T
compatible. The medium type can be configured via the
RSET8139.exe program included on the utility disk.
The Ethernet port provides a standard RJ-45 jack on board. The
network boot feature can be utilized by incorporating the boot
ROM image files for the appropriate network operating system.
The boot ROM BIOS files are combined with system BIOS, which
can be enabled/disabled in the BIOS setup.
7.2

Installation of Ethernet driver

Before installing the Ethernet driver, note the procedures below.
You must know which operating system you are using in your
PCM-5820, and then refer to the corresponding installation flow
chart. Then just follow the steps described in the flow chart. You
will quickly and successfully complete the installation, even if you
are not familiar with instructions for MS-DOS or WINDOWS.
Note:
7.2.1 Installation for MS-DOS & Windows 3.1
If you want to set up your Ethernet connection under the MS-DOS
or Windows 3.1 environment, you should first check your server
system model. For example, MS-NT, IBM-LAN server, and so on.
Then choose the correct driver to install in your panel PC.
The installation procedures for various servers can be found on
CD-ROM; the correct path being "D:\5820\Ethernet.100\wfw311".
68 PCM 5820/5820L User's Manual
The windows illustrations in this chapter are
examples only. You must follow the flow chart
instructions and pay attention to the instructions
which then appear on your screen.