Audio Interfaces (Cn5, Cn1); Audio Connector (Cn5); Cd Audio Input Connector (Cn1); Audio Power Source Setting (J1) - Advantech PCM-5820 Manual

2.14 Audio interfaces (CN5, CN1)

The PCM-5820/5820L is equipped with a high quality audio
interface, which provides 16-bit CD quality recording and play-
back as well as OPL3 compatible FM music. It is supported by all
major operating systems and is completely compatible with Sound
Blaster Pro.

2.14.1 Audio connector (CN5)

The PCM-5820/5820L provides all major signals on a 16-pin flat-
cable connector (CN5). These audio signals include Microphone in
(mono), Line in (stereo) and Speaker out (stereo). An adapter cable
is needed if traditional telephone jack connectors are used for these
audio signals.

2.14.2 CD audio input connector (CN1)

All CD-ROM drives can provide analog audio signal output when
used as a music CD player. The CN1 is a connector to input CD
audio signals into the audio controller. The audio cable of your
CD-ROM drive is suitable for connection to CN1.

2.14.3 Audio power source setting (J1)

The PCM-5820/5820L is designed to work with a single +5 V
power supply as audio interfaces usually function under +5 V.
However, most audio controllers require an independant +12 V
power source since this avoids noise interference from other digital
circuits. By using J1, the PCM-5820/5820L's audio interface can
also accept +12 V power sources for improved audio quality.

Table 2-3: Audio power source setting

1 2 3 1 2 3
* default setting
Chapter 2 Installation 21