Table of Contents
Advertisement
Attaching Antenna Mount Plate & LNB Park Plate
1.
Remove Antenna Unit from wooden transit packaging
2.
Remove mounting plate from Antenna Unit by removing 6 x M6 nuts using 10mm spanner
3.
Clean roof, Mounting Plate and LNB Park Plate in accordance with adhesive manufacturer's guidelines
4.
Mark a centre line for the antenna making sure dish will not overhang vehicle
5.
Align notches on plate with centre line
6.
Mark the position of 6 screw fixing holes
7.
Mark position of LNB Park Plate
8.
Drill 6 x 2.5mm pilot holes into the roof
Direction of travel
Central Line
9.
Apply adhesive to entire surface of Antenna
Mounting Plate and LNB Park Plate and firmly
place them into position
Note:
• Follow manufacturer's instructions when applying adhesive. Do not travel until adhesive has
cured noting that curing times vary with weather conditions
• Take care when working at heights. Always follow ladder manufacturer's safety advice
• Use creeper boards where necessary to ensure roof construction can support your weight
• Power tools should be used in accordance with manufacturer's instructions
Antenna Mount Plate
10.
11.
230mm 65cm (MXL028/65 all variants)
350mm 85cm (MXL028/85 all variants)
Place a small amount of adhesive into each hole
before screwing plate to roof
Wipe off excess adhesive with a cloth
LNB Park
Plate
6 x No. 10
screws
Page 7
Advertisement
Table of Contents
