Table of Contents
Advertisement
Interfaces and Daughterboards
Interfaces
Your printer supports the following interface cards:
„
CrownNet for Ethernet 10BaseT/100BaseTX (TCP/IP, NetWare, Ether-
talk, LAN Manager/LAN Server) for an additional CrownNet for Ethernet
connection
„
CrownNet for Token-Ring (TCP/IP, NetWare, LAN Manager/LAN Server)
„
Crown for DECnet-TCP/IP
You can install one of these interface cards in addition to the two standard
interfaces—parallel and CrownNet for Ethernet (TCP/IP, NetWare, Ethertalk,
LAN Manager/LAN Server). The printer's Simultaneous Interface Operation
(SIO) allows all of these interfaces to be active at the same time. In other
words, your printer can simultaneously communicate through all three ports
with three hosts, either computers or networks.
If installing a Token-Ring optional interface card, see the "Notices" section in
the Installation Guide for FCC compliance classification information.
What's in the Kit?
An optional interface kit includes the following:
„
An interface card
„
Interface documentation (in hardcopy and/or on CD-ROM)
The kit may also include additional parts not required for network interface
installation on this printer.
Installation
Attention
It's very important to protect the printer controller board and any
associated circuit boards from electrostatic damage. Before performing
this procedure, review the antistatic caution on page 105. In addition,
always handle circuit boards by the edges only.
Interfaces and Daughterboards
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
123
Advertisement
Table of Contents
