Table of Contents
Advertisement
Installation
Standard Extender Kit Installation
Notes:
1. See the Product Features section of this manual for information on your model's maximum
supported distances and resolutions.
2. Test to make sure the entire installation works properly before pulling cables through ceilings/walls.
3. To achieve maximum distance and performance, use 24 AWG solid wire Cat5e/6 or 23 AWG solid
wire Cat6a cable. Using stranded wire cable or cable with a gauge (AWG) size higher than that
recommended will result in a shorter extension distance. Higher gauge cabling such as 26 AWG
has a more limited transmission capability than lower-gauge cabling. All Tripp Lite N202-Series
Cat6 cables are made with 24 AWG solid wire cabling. Extended lengths of 23 AWG solid wire
Cat6a cable are available from Tripp Lite as a custom order.
4. When using a 28 AWG HDMI cable and displaying video resolutions higher than 1080p, the HDMI
cables connecting the source and the monitor must not exceed 6 feet. When using a 24 AWG
HDMI cable, you must not exceed a 16-foot length.
5. The transmitter and receiver included in each kit are compatible with each other only. You
cannot mix and match transmitters and receivers from different kits. For example, a BHDBT-K-SI
transmitter will not work with a BHDBT-K-SI-ER receiver.
6. Each kit includes one set of IR-IN and IR-OUT cables. It is up to the user to determine whether
the cables will be used to extend an IR signal from the transmitter side to the receiver side, or
the receiver side to the transmitter side. In most installations, the cables will be used to control
the HDMI source (e.g., Blu-ray player) from the same location as the monitor connected to the
receiver.
Local
Transmitter
Blu-Ray Player
15-01-181-933418.indd 6
HDMI Cable
IR-OUT
RS232
IR-IN
Serial
Computer
HDMI Cable
RS232
Serial
Flat Panel
6
Remote
Receiver
IR-OUT
IR-IN
Bar Code Scanner
or Touch Screen
2/6/2015 3:33:58 PM
Advertisement
Table of Contents
