Pairing Instructions; Installation - Tripp Lite B164-101-WIR Owner's Manual

Pairing Instructions

1. Power the IR Transmitter and Receiver units using the included USB Power
cables.
2. Press and hold the IR Receiver's LOCK ID button for 4 seconds or until the
built-in blue IR CON LED begins to blink.
3. Once the IR Receiver unit is in pairing mode, press and hold the IR
Transmitter's LOCK ID button for 4 seconds or until the IR Transmitter unit is
paired with the IR Receiver unit.
Note: The blue IR CON LED on the IR Receiver unit will stop blinking and turn off
once the IR Transmitter and Receiver units have been paired.

Installation

Note: The TX and RX units must be paired before use.
HDMI Display
1. Position the IR Transmitter unit in a place where you wish to control your IR-
enabled device from up to 656 ft. (200 m) away.
2. Connect the included IR-In cable to the IR Transmitter unit.
3. Place the IR Receiver unit near the IR-enabled equipment you wish to control
(Blu-ray™, cable box, etc).
4. Connect the included IR-Out cable to the IR Receiver unit.
Note: Make sure there are no obstructions between your IR-enabled equipment and
the IR-Out cable's emitter head.
5. Reconnect the included USB Power cables to the IR Transmitter and Receiver
units.
18-11-124-9338E8.indb 4
Transmitter
(TX)
IR Input
Receiver
(RX)
IR Output
4
DVD
12/7/2018 5:58:44 PM