Tripp Lite BHDBT-K-SI Owner's Manual page 9

Installation
4. Connect the IR-IN cable to the IR-IN port on the local transmitter unit.
Note: The IR-IN unit accepts a signal from a remote control and sends it to a device controlled
on the other end of the installation. Position the IR-IN unit in an unobstructed area that can
easily accept a remote control signal.
5. Connect the IR-OUT cable to the IR-OUT port on the local transmitter unit.
Note: The IR-OUT unit receives a signal from the remote control on the other end of the
installation and sends it to the device being controlled. Locate the IR-OUT unit in an area close
to the remote-controlled device (e.g., Blu-ray player, TV).
6. Connect the external power supply to the local transmitter unit and plug it into a
Tripp Lite Surge Protector, Uninterruptible Power Supply (UPS) or Power Distribution
Unit (PDU).
7. Connect the RJ45 Output port on the local transmitter unit to the RJ45 Input port
on the transceiver unit using Cat5e/6/6a cable.
8. (Optional) Connect the HDMI monitor to the HDMI Output port on the transceiver
unit.
9. Connect the external power supply to the transceiver unit and plug it into a Tripp Lite
Surge Protector, Uninterruptible Power Supply (UPS) or Power Distribution Unit (PDU).
Up to five transceiver units can be inserted in-between the transmitter and receiver
units of your HDBaseT HDMI over Cat5 Extender Kit. To connect additional transceiver
units, repeat steps 7 through 9. To complete your installation with a receiver unit,
proceed to step 10.
10. Connect the RJ45 Output port on the last transceiver unit in the chain to the RJ45
Input port on the receiver unit using Cat5e/6/6a cable.
11. Connect the HDMI monitor to the HDMI Output port on the remote receiver unit.
12. Connect the included 3.5 mm male-to-DB9 male adapter cable to the RS-232
port on the remote receiver unit, then connect the RS-232 device to the adapter.
13. Connect the IR-IN cable to the IR-IN port on the remote receiver unit.
Note: The IR-IN unit accepts a signal from a remote control and sends it to a device controlled
on the other end of the installation. Position the IR-IN unit in an unobstructed area that can
easily accept a remote control signal.
14. Connect the IR-OUT cable to the IR-OUT port on the remote receiver unit.
Note: The IR-OUT unit receives the signal from the remote control on the other end of the
installation and sends it to the device being controlled. Locate the IR-OUT unit in an area close
to the remote-controlled device (e.g., Blu-ray player, TV).
15. Connect the external power supply to the remote receiver unit and plug it into a
Tripp Lite Surge Protector, Uninterruptible Power Supply (UPS) or Power Distribution
Unit (PDU).
16. Turn on the power to the HDMI source and RS-232 serial source.
15-01-181-933418.indd 9
9
2/6/2015 3:33:59 PM