Tripp Lite BHDBT-K-SI Owner's Manual page 12

Installation
14. Connect the 3.5 mm male-to-DB9 female adapter cable included with the receiver
unit to the RS-232 port on the receiver unit, then connect the RS-232 device to
the adapter.
15. Connect the IR-IN cable included with the receiver unit to the IR-IN port on the
remote receiver unit.
Note: The IR-IN unit accepts a signal from a remote control and sends it to a device to be
controlled on the other end of the installation. Position the IR-IN unit in an unobstructed area
that can easily accept a remote control signal.
16. Connect the IR-OUT cable included with the receiver unit to the IR-OUT port on the
remote receiver unit.
Note: The IR-OUT unit receives the signal from the remote control on the other end of the
installation and sends it to the device being controlled. Locate the IR-OUT unit in an area close
to the remote-controlled device (e.g., Blu-Ray player, TV).
17. Connect the external power supply to the remote receiver unit and plug it into a
Tripp Lite Surge Protector, Uninterruptible Power Supply (UPS) or Power Distribution
Unit (PDU).
18. Repeat steps 12 through 17 for each additional RJ45 Output port on the
transmitter that you will be connecting to a receiver unit.
19. Turn on the power to all HDMI and RS-232 serial devices in the installation.
20. Press the switch next to each set of Output LEDs to change the source being
displayed on the corresponding Output monitor. You can also use the included
remote control to switch between sources. To switch the source being displayed,
press the button on the remote control of the desired Output port.
Note: The same four-button remote control is included with both the BHDBT-T-SI-4X2 and
BHDBT-T-SI-4X4. Buttons 3 and 4 will not be used for the BHDBT-T-SI-4X2.
For details on using Terminal Emulation Software to control the switch, refer to the
RS-232 Serial Control section of this manual.
15-01-181-933418.indd 12
12
2/6/2015 3:33:59 PM