Heater Operating; 1- Controls And Features - hergom CRAFTSBURY Installer Manual

Table of Contents

Advertisement

Once your CRAFTSBURY heater has been installed, and
connected to the chimney, it is ready to have the fire lit.
Before lighting the heater for the first time, it is necessary that
you get familiarised with your heater's different control systems and
features, how to choose the wood logs, how to light it and use it on a
daily basis.
Though the operating of your heater is easy, the combustion
process of solid fuels is complicated, as several factors intervene,
and time and experience are needed to understand how it is carried
out.
ALWAYS TAKE INTO ACCOUNT that the heater produces
heat and therefore you must keep children, clothes, furniture...away
from it as the contact with it may cause burns.
We will next give you some advice on how to adequately get to
know your heater and its operating, which we request you read
carefully:

2.1.1- CONTROLS AND FEATURES

Before lighting any fire, get familiarised with the location and
operating of the controls as well as the parts of your heater and learn
how they are used. (See Fig. 2 Pag. 5)
For your own safety in no case should you modify any of these
parts.
FRONT DOOR CONTROL:
access the inside of the hearth to load the wood logs in your heater
and to clean it, and it provides a view of the fire through the glass. To
open the door, lift up the control handle up to the position (as on a
clock) of 10 o'clock and pull from the door. Fig.15. To close the door,
push the door against the frame lowering the control handle to the
position (as on a clock) of 8 o'clock.
ASH PAN DOOR CONTROL: Open this door when you need
to remove the ashes from the heater. To open the door push the
control handle slightly upwards until the closing latches are freed
from their pocket. (Fig. 16), and without releasing it, lower the door
lightly downwards, until the door leans against the stoppers located
under the ash pan drawer. (Fig. 17).
In order to close it, the process is the other way round. Lift the door
holding it from the control handle upwardly till the closed position and
slightly pressing in the direction of the heater, lower the lever as far
as the closing latches fit into the initial location. (Fig. 19) So this
operation results easier, it is recommended to carry it out two
handed.
PRIMARY AIR CONTROL: The primary air control permits to
regulate the amount of air that enters the hearth. Moving the control
towards the left the primary air entrance increases. (See Fig.-19)
USE MANUAL

2.1- HEATER OPERATING

The front door allows you to
OPEN
$%5,5
CLOSE
&(55$5
Fig.15
Fig.16
7RSH GH
SXHUWD
Door
stopper
Fig.17
Fig.18
PRIMARY
AIR
REGULATION
Fig.19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents